The membrane switch, also known as the light touch keyboard, is a set of graphics, buttons, and marker symbols displayed by a multi-plane combination seal made of soft materials such as PC, PVC, PET, FPC and double-sided tape. The conductive and electronic switch functions in one plastic electronic product. So, do you know what the paste switch is to do? Here is a brief introduction by Xiaobian:
1. Clean the surface of the membrane switch to be fitted, and the surface to be fitted is required to be flat, rust-free, oil-free, and dust-free.
2. Compare the size, put the membrane switch to the place to be pasted to compare the size of the position is just right.
3. Remove the centrifugal paper from the bottom of the membrane switch from the side by about 10 mm.
4. Then place the membrane switch in the corresponding position and stick a part, then slowly remove the remaining centrifugal paper (in the case of not exceeding 15 degrees), and then paste it to the corresponding position.
5. If the membrane switch of the reverse centrifugal paper is torn off during the pasting process, it should be placed first, and should be placed on the reverse side to prevent sticking to other objects.
6. Note: Paste can not be repeated, need to be done in one time, tear angle can not exceed 15 degrees, try to press the hand, be sure to put it on the table and then press it, can not take it in your hand, otherwise it will Affect the life of the membrane switch.